Quant 3D Q150 Betriebsanweisung PDF herunterladen (Seite 113)

Network requirements

The QuantStudio

3D Digital PCR Instrument supports IPv4 TCP/IP communication

and provides two methods for integrating the device into a local area network (LAN,

also see “Materials required“ on page 97):

• The fast Ethernet adapter (10/100 Mbps) with a RJ45-type connector on the rear

panel of the QuantStudio

3D Instrument allows you to connect the device

directly to a standard network port using a standard Category 6 Ethernet cable of

the required length.

• An optional IEEE 802.11b/g/n Wireless Dongle connected to the QuantStudio

Instrument enables a connection to compatible wireless hotspots.

Note: See the documentation accompanying the Wireless Dongle for

compatibility information.

The QuantStudio

3D Digital PCR Instrument requires the following if connected to a

network:

• The room where the QuantStudio

3D Instrument will be deployed must contain

at least one active network jack.

• If the QuantStudio

3D Instrument will be located more than 10 feet from the

network jack, you must provide a shielded Category 6 Ethernet cable of sufficient

length.

• If dynamic network configuration is not available, a static IP address must be

reserved for the QuantStudio

3D Instrument.

• The configured DNS server must resolve internet domain names (such as

"apps.lifetechnologies.com/" and "pool.ntp.org").

The names of any local file servers used as data destinations must also be

available through DNS, or optionally WINS.

• If the QuantStudio

3D Instrument will transfer experiment (.eds) files directly to

the QuantStudio

3D AnalysisSuite

™

Software, then the instrument must have

outbound Internet access through port 443/HTTPS to

apps.lifetechnologies.com/quantstudio3d/.

• If the QuantStudio

3D Instrument will use Network Time Protocol (NTP) for

date/time synchronization, the instrument must have outbound Internet access

through port 123/UDP to the server pool at pool.ntp.org.

• If the QuantStudio

3D Instrument will transfer experiment (.eds) files to a

Windows

-based or SAMBA file server, network credentials must be provided

for authentication.

In addition to the requirements above, if the QuantStudio

3D Instrument will be

connected to a wireless network, the access point must support:

• IEEE 802.11b/g/n wireless standards

• WEP, WEP-Enterprise, WPA- Personal, or WPA2-Personal security

Appendix D Specifications and Layout

Network requirements

QuantStudio

3D Digital PCR System User Guide

113

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 121 122

Kommentare zu diesen Handbüchern

Keine Kommentare

Quant 3D Q150 Betriebsanweisung Seite 113

Kommentare zu diesen Handbüchern